|
T-1232E SMT 12mm-Width Type
(Seperate excitation IC drive feasibility)
 |
| * |
Slim, low-profile design (5.7mm max.) and high power. |
| * |
Supports reflow soldering. (Supports Pb free soldering) |
| * |
Supports automatic mounting (Tray type) |
| * |
Secondary Double-Pin .( Fail-safe) |
| * |
High efficiency possible by using separate excitation IC. |
| * |
LCD monitor (up to 23inches) |
| * |
LCD TV (up to 23inches) |
|
| Electrical characteristics |
| Part No |
Max.output
(W) |
Frequency
(KHz) |
Max. output voltage
(Vo-p) |
Output Open voltage |
Withstand voltage(AC60Hz)(Vrms) |
| Between 1st & 2nd windings |
Between 2nd winding & core |
| CD-T-1232E |
6(8)<*1> |
30-200 |
2000<*2> |
2800<*3> |
500 |
500 |
Connection diagram
| Gap(4Item)vs. AL |
| Gap [mm] |
AL [nH/N²] |
| NON |
- |
| 0.10 |
110 |
| 0.15 |
90 |
| 0.20 |
80 |
|
|
|
* Notes
To match your exact needs, please contact us for information on T-1232E customization. The T-1232E cannot be used in a floating type circuit.Be sure to ground the No.5,6 pin. Pin5-6and7-8 are connected inside the bobbin.
*1 Max output power and efficiency vary according to operating conditions.
(Up to 8W according to operating conditions).
*2 It varies according to the number of winding turns.
*3 It is within 3sec or less and varies according to the number of winding turns.
 |
|
Note: Must not pattern on the transformer bottom
|
|
Unit: mm
|
| Recommended landing pattern and drop dimensions |
 |
|
Unit: mm
|
|
